Operating instructions

Cordless Hedge Trimmer Operatorʼs Manual
Quick blade stop
In order to avoid injuries through cuts, the blade will stop
in max. 0.1 sec. when one of the two switches is released.
Blade safety rail (Fig. 12)
The cutting blade is set back by 0.32” (8mm) from the
passive blade teeth which prevents injuries due to unin-
tentional body contact.
Impact protector (Fig. 12)
The extended guide rail prevents unpleasant shocks
(blade recoil) being transmitted to the operator due to im-
pact with solid objects (wall, ground etc.).
Gear protection feature
If solid objects are caught in the cutting blade and jam the
motor, switch off the machine at once, disconnect the bat-
tery from the power tool, remove the object and continue
with the work.
The equipment is also tted with an overload cutout, which
protects the gears against mechanical damage in the
event of blade jams.
STORING THE HEDGE TRIMMER AFTER USE
The hedge shears must be stored such that there
is no danger of injuries being caused to persons
by the cutting blades!
Important note: The shearing blades should be cleaned
after each use.(see also Section Maintenance).This will
considerably increase the service life of the device. Please
use a lubricator that is not harmful to the environment. Then
put the shears in their case with the cutting blades rst.
ENVIRONMENTAL PROTECTION
Recycle unwanted materials instead of disposing
of them as waste. All tools, accessories and pack-
aging should be sorted, taken to a recycling centre
and disposed of in a manner which is compatible
with the environment.
When the rechargeable batteries are no longer
required, they must be disposed of in an environ-
mentally protective way. Run the battery complete-
ly down and then remove it from the tool.
The rechargeable battery contain Lithium-ion (Li-
ion). They are recyclable. Take them to your local
recycling center to be disposed of properly. Do
not incinerate Li-ion battery as they may explode
when exposed to re. Do not attempt to open the
battery packs.
12