Replacement Part List

7Contact us at www.mantis.com or your local authorized Mantis
®
Dealer
Assembly
B. LOWER HANDLE ASSEMBLY
To identify part numbers, see page 6 and 15.
1. Use the protective cardboard sleeve to stabilize your
tiller. Stand the motor assembly (#62) up. (Picture 1)
2. Lay the handle parts within easy reach. You’ll need one
of the handle clamps (#19) and one of the lower handles
(#10). Note that the lower handles have a short leg on
one end.
3. Fit the handle clamp along the outside of the short leg.
Line up the holes on the clamp and the leg.
4. Choose one of the two 3-inch bolts (#20). Slide it through
the first set of holes — near the elbow where the lower
handle curves. (Picture 2)
5. Now slide the other lower handle onto the 3-inch bolt. Fit
the other clamp onto this other handle’s short leg. Add a
nut and tighten finger tight. (Picture 3)
6. Locate the worm gear housing. It starts just above — and
extends down through — the tiller’s red fender guard.
You’ll notice that there’s a recessed channel on either
side of the housing’s top. (Picture 4.)
7. Take the lower handles that you’ve just put together.
Slide them into the two recessed channels.(Picture 5.)
Make sure you insert them from the rear of the tiller - so
that the bolt fits along the back of the housing.
8. Slide the second 3-inch bolt through the second set of
holes in the short legs and clamps. Add a nut and tighten
finger tight.
Picture 1
Picture 2
Picture 3
Picture 5
Picture 4
NOTE:
The nuts are self locking, but you must use a wrench
to tighten them completely.