Replacement Part List

6 Mantis
®
Classic Electric Tiller Operator’s Manual
Assembly
*These numbers are the same numbers shown on the Parts Layout
on pages 15 and 16.
**This Key # is for assembly purposes only.
12
20
13
16
18
53
17
19
62
54, 55
14
1
7
10
Improper assembly of this tiller can result in serious
injury. Make sure to follow all instructions carefully.
If you have any questions contact our factory at
1-800-366-6268 or an authorized dealer.
A. PARTS
Your Mantis Electric Tiller comes partially assembled. You
must install only the handlebars, the handle brace, and
the tines. This will take just a few minutes if you follow the
directions.
First, take all items out of the carton. But do not remove the
cardboard from around the tiller’s base.
The list below, shows the parts that come with your tiller.
Check to make sure you have them.
The bag of hardware is in the plastic bag containing the
Operator’s/Parts Manual.
To assemble your Mantis Electric Tiller, you’ll need two 7/16”
wrenches. We suggest that you install all nuts and bolts only
“finger tight” — that is, one-half to one full turn — until you’ve
completed assembly. The nuts are self locking, but you
must use a wrench to tighten them completely.
Key Qty. Description
7 1 Upper Handle Assembly
1 1 Upper Handle Trigger Assembly
10 2 Lower Handles
54/55 1 Pair tiller/Cultivator Tines
62** 1 Motor Assembly (includes Fender Guard, Worm
Gear Transmission & Complete Housing)
14 1 Handle Brace
1 Bag of Hardware Containing:
16 2 Round Head Square Neck Bolts
17 4 Lock Nuts
20 2 Bolts (3” long)
53 2 Tine Retaining Pins
19 2 Handle Clamps
13 2 Bolts (1” long)
12 2 Knobs
18 2 Cable Clamp