Instructions / Assembly

Key No. Part No Description Qty
1 410114 Bottom Bracket 1
2 410110 Top Bracket 1
3 M9452 1/4-20 Whiz Head Screws 2
4 410112 Spring 2
5 410111 Stand 1
6 410524 Washer 2
7 410525 Cotter Pin 2
How to Mount
Lean Tiller handles against a firm surface, so
the tiller stands upright.
Place the bottom bracket (Key No. 1) under the
lower handles, below the plastic carrying
handle, as shown in the photos below.
Place the top bracket (Key No. 2) over the
lower handles and line it up so the screw holes
in both brackets line up.
Insert screws (Key No. 3) through holes in the
top bracket and screw them into the bottom
bracket (Key No. 1) by hand.
Then use a wrench to completely tighten both
screws.
Make sure that the Kickstand is lined up with
the handles. If not - loosen the screws and
re-adjust.
Tiller Kickstand
Assembly Instructions