Operating Instructions

Air Rie Scope
3-9x32AO
3-9x40AO
4-12x40AO
Caution: Before mounting your scope, be sure to read carefully and follow the operating instructions from this manual. Be sure
that your gun is not loaded before you attempt to install scope. Always follow safe gun handling procedures. It is your duty to
obey all laws regarding the use and ownership of this scope.
• Always keep the muzzle pointed in a safe direction.
• Keep your airgun unloaded when not in use.
• Be sure of your target and what may be behind it.
• You and others with you should always wear eye and ear protection while shooting.
• Be sure to familiarize yourself with the airgun you are using.
Mounting
Proper mounting assures that the scope is aligned to the barrel and is rigged rmly in place for the best accuracy. Choose a good quality pair of
1-inch scope rings of the proper height for use with your scope. The rings need to t onto a 3/8” (11mm) dovetail rail, weaver rail, or Picatinny
rail depending on the type of rail you have on your rie. Be sure that the scope can be mounted at the ideal location and is clear off the prole
of the receiver and barrel. Sometimes you may need to remove your standard rear sight.
First, locate the desired mounting location for your particular gun. Loosen the base clamping screws at the bottom of the rings. Place the bottom
of the rings onto the rail with the scope eyepiece facing towards the butt end of the stock, center it up on the rail, then tighten the ring clamp
screws. Make sure the ring bottom is properly aligned with the rail and is fairly locked in place. Next, loosen the ring cap screws holding the top
covers of the rings. Look through the scope and rotate and align the reticle lines vertically and horizontally. Move the scope back and forth to
get a full sight picture from normal shooting position and get proper eye relief set up. The eye relief on this scope should be 3 inches or longer.
Slightly tighten ring cap screws. Check the alignment and eye relief from shooting position before fully tightening the screws.
Fast Focus Ring
At the end of the scope eyepiece there is an eyepiece focus ring. Rotate the focus ring to
focus the reticle to your eye. Adjust until both the reticle and target appear to be sharp.
Power Zoom Wheel
The power zoom wheel, when turned, allows a change in scope magnication from
3x to 9x (4x-12x in the case of the 4-12X40AO).
Adjustable Objective
The scope can be more precisely focused by rotating the adjustable objective.
Use the yardage marks as reference when rotating the adjustment ring to eliminate parallax.
© Air Venturi 2017 / www.airventuri.com / 216-292-2570
Adjustable Objective
Power Zoom Wheel and Fast Focus Ring