Installation

MantelMount MM700R Recess Box Kit Addendum PAGE 7
18a
CENTER STUD:
If a center stud was cut to make room for the Recess
Box, the loose ends of that stud must be attached to
the Recess Box at the top and bottom. Locate the ends
of the stud through the holes shown and use two wood
screws (not included) at both top and bottom.
Attach the Recess Kit using Lag Bolts {17} and Washers
{10} directly into the centers of the studs. Add an
additional set of Washers {10} between the Braces {63}
and the wall (tape them to the wall beforehand if needed)
to compensate for the thickness of the Recess Box flange.
The screw heads that attach the Recess Braces to the
Recess Box will need to be pressed or tapped into the
drywall so that the flange is flush with the wall.
!
CAUTION:
Do Not overtighten Lag Bolts {17}. Tighten only until the
washers are firmly against the Braces. Damage due to
overtightening can cause property damage or injury.
Attach the Lifting Mechanism {35} into the Recess Box
using Screws {14} from the MM700 parts kit. Tighten
securely.
When the MM700 installation is complete, slide or snap on
the paintable Brace Covers {64}.
Insert Rubber Bumpers {65} into each end of the
Horizontal Brace {34} to protect the wall.
Return to PAGE 10 of the
MM700 Installation Manual.
19a
DO NOT
damage or scratch
the rods of the
Gas Springs!
Cut end
of STUD
{65}
{64}