Installation Guide

SURFACE MOUNT (non-recessed) installation using the
Horizontal Braces {31} to attach to existing wall studs:
The Horizontal Braces can reach studs that are up to
34 inches (875mm) apart. They attach flush to the back of the
Lift Housing {30}.
RECESSED installation using the Horizontal Braces {31} to
attach to existing wall studs:
The Horizontal Braces attach to the flange on the front of the
Lift Housing {30}. Use the included Template to mark the
location to cut the drywall. This installation is easiest when
there is no center stud that needs to be cut to make room.
SURFACE MOUNT (non-recessed) installation onto stone or
concrete walls using the six holes in the back of the Recess
Frame {30}. The lower Access Cover {32} must be removed to
access the lower holes.
The wall must be solid stone or concrete that can hold five times
the weight of all combined equipment. This surface must not be a
facade or non-structural material.
Use concrete anchors (not included) to attach mount to surface.
RECESSED installation using the included 2x4 Stud Brackets {53}.
When studs are far apart, when a center stud needs to be cut, or
when the cleanest look is desired, sections of horizontal 2x4 can
be installed through the cutout. They provide a solid structure for
the mount without the need for the Horizontal Braces. The mount
is attached with Lag Bolts through the holes in the front flange of
the Lift Housing {30}. Any studs that were cut can be reattached
to the new sections of 2x4.
Do Not overtighten Lag Bolts {13}. Tighten only until the
washers are firmly against the wall plate. Damage due to
overtightening can cause property damage or injury.
MantelMount MM860 PAGE 9
{20} {17}
{13} {11}
{20} {17}
{13} {11}
{13}
{11}
Concrete Anchoring Hardware
Not Included
Installation Options:
!
CAUTION:
{32}