Installation Guide

Down Button:
Opens the Mount
Program Button
and
Status Light
MantelMount MM860 PAGE 7
UP
DOWN
RIGHT
LEFT
HOME
SET
M 2
M 1
Lay MantelMount on a flat, stable surface. Press and hold
the DOWN button on the Remote until the arm is
perpendicular to the Housing. Operate the LEFT and RIGHT
buttons to verify the swivel operation. Return the arm to
the HOME position before installation.
To start using the MantelMount MM860, the Remote Control
must be linked to the mount. This process is called “Pair”.
To pair the Remote, follow these steps:
Pairing the Remote to MantelMount: Verify Proper Remote Operation:
MantelMount MM860 comes with an RF Remote Control. This Remote does not need to be pointing
at the mount in order to control the mount; in fact, the Remote will send commands to the mount
even from other rooms in the house. It is very important to operate the Remote only when the
mount is in sight. Otherwise, always store the Remote in a safe place away from children.
MantelMount RF Remote Control
* Press any button to immediately stop mount movement *
UP
DOWN
RIGHT
LEFT
HOME
SET
M 2
M 1
Hold to Swivel Left
Set Soft Stops and Memory Positions
Hold to Raise the Mount
Press for Memory 1 Position
Hold to Swivel Right
Can be programmed
with the SET button
Press to Fully Raise the Mount
Hold to Lower the Mount
Press for Memory 2 Position
Blue Indicator Light
!
CAUTION:
JOGGING BUTTONS:
Press and hold any of
these four buttons for
continuous movement.
Note:
Setting the Soft Stops
with the SET button
can only be done
when the mount is in
“Program” mode.
See Page 11.
PRESS BUTTONS:
Single-Press any of these
four buttons for
automated function.
10 11
a. Press any button on the Remote to verify the blue light works.
b. Attach Power Cable {52} to the mount and plug into wall outlet.
c. On the side of the electronics housing, press the “Program”
Button for 3 seconds until the green Status light rapid blinks.
d. Press and release the SET button on the remote. Pairing is
complete and is confirmed if the Status light stops blinking.
LEFT
MOTOR
ETHERNETIRDA
RIGHT
MOTOR
MM-MC2
Input 100-240V ~ 50/60Hz, 1.6A
860
Status Program Reset
{52}
Power Cable