Installation Guide

ManualsBrandsMantelMount ManualsTV Wall MountsMantelMount Motorized Drop Down & Swivel TV Mount

The Vertical Braces {27} are always mounted higher than

the bottom of the TV. However, the Brace Extenders {28}

will be mounted one of two ways:

Without a Sound Bar, if needed - The Brace Extenders

are installed slightly above the bottom of the TV. Use the

Extenders for holes that are low on the TV.

With a Sound Bar - The Brace Extenders are installed

below the TV with enough room to install the Sound Bar

onto the Horizontal Brace {29}.

Attach the Vertical Braces {27} to the TV so the bottoms of

the Vertical Braces are at least eight inches higher than the

bottom of the TV (so that the TV hides the mount housing).

NOTE: If all the screws for the back of the TV can fit into the

TV Vertical Braces {27}, and a soundbar is not being used,

then the Brace Extenders {28} do not need to be installed.

Attach the TV Horizontal Brace {29} with Screws {18} if a

soundbar is used. Each Extender {28} must be slid on

from the outer ends because there are thread inserts

blocking the center of the Brace.

Attach the Extenders to the Vertical Braces using

Screws {19} and Nuts {16}. Soundbar Wings {59} are

optional.

Measure the distance from the bottom of the Vertical

Braces {27} (not the Extenders) to the bottom of

television or Sound Bar.

Write down this distance to use in Step 9.

Use this distance in Step 9

Without

Sound Bar:

Extenders are

only needed for

TV holes that

are close to the

bottom of the TV

Vertical Braces:

Always higher

than the bottom

of the TV

With

Sound Bar:

Extenders are

a few inches

below the TV

8 - 11 INCHES

(Less if a Soundbar is used)

8 to 11

INCHES

{28}

{27}

Bottom of

Vertical Brace

Bottom of TV

MORE THAN

8 INCHES

Bottom of

Vertical Brace

Bottom of

Sound Bar

MantelMount MM860 PAGE 5

5 6

7 8

For Sound Bar Only

{16}

{19}

{28}

{18}

{59}

{59}{29}