Installation Guide

Network Adapter
Completed Scan
Discover MantelMount Devices
Ethernet ( or WiFi )
Network Adapter Information:
Subnet : 255 . 255 . 255 . 0
MAC: ECAAA02854DD
IP : 192 . 168 . 150 . 2
192.168.150.111 D83AF584E321
IP MAC Hostname
Scan Network
MM860
Conguration
MM860 Toolbox
X
Module 1: Auto-Discovery
Module 2: MM860 Configuration
(Device Page)
Module 2:
(Network Page)
PAGE 16 MantelMount MM860
NETWORK DEVICE
MAC Address:
Host Name:
MantelMount_f30190
d8:3a:f5:f3:01:90
192.168.150.111
192.168.150.1
255.255.255.0
81
81
IP address:
Determine network settings
automatically with DHCP
Use these network settings:
Subnet:
Gateway:
TCP Port:
UDP Port:
Save Settings
Network Information
Network Settings
NETWORK DEVICE
This device is running rmware version xxx (A)
There are currently no software updates available
Enabled (recommended)
0.00
0.00
Normal
O
Smooth Start Mode:
Current Swivel (Degrees -L or +R):
Current Elevation (Degrees):
Temperature Sensor:
0
55
15
Current TV Power:
mA
mA
mA
TV “On” Power Threshold:
TV “O” Power Threshold:
TV Status:
Check for update Local Update
Save Settings
Device Conguration
Status:
ALPS TV Settings: (Auto Lowering Power Sensing):
Select WiFi only if the MM860 is
connected to a Network and the
setup PC is using WiFi.
All other installs use Ethernet.
Scans the Network to find all
MantelMount products.
If the MM860 is not on a Network, this
will connect with the MM860 only if the
PC is set to the correct IP Address:
192.168.150. 2
Opens the Configuration Module 2
Opens the Toolbox Module 3
Progress Bar
Status
After a Scan, this will display
only MantelMount products.
Select the correct MM860 here.
Launch the MM860 Utility:
Module 1 will open:
“Discover MantelMount Devices”.
Use the “Device” Page to adjust the MM860 parameters if needed.
These settings are stored onboard the MM860.
25
Open the Configuration Module:
26
ALPS
Firmware
Update
(Network)
Firmware
Update
(Manual)
Use the “Network” page to assign
a specific Static IP Address for
Home Automation systems.
HOME AUTOMATION SYSTEMS:
After the IP Address for the MM860 is assigned,
you can use the MM860 Driver for your
Automation System to set up the MM860.
Drivers are located at MantelMount.com (Dealers)