Installation Guide

• Home network will automatically assign an IP Address to MM860 via DHCP
MM860 can be manually assigned a Static IP Address for home automation systems
• MM860 will automatically check online for Firmware updates
• MM860 can be configured with a PC or home automation system over the network
• The MM860 Utility must be loaded onto the PC or Laptop (Windows OS) before Installation
MantelMount MM860 is connected to a home network (LAN):
Determine how the MantelMount MM860 will be used:
MantelMount MM860 is not connected to a network:
PAGE 14 MantelMount MM860
Ethernet
Home Network
Ethernet
or WiFi
• PC (or laptop) is temporarily connected to the MM860 directly via Ethernet cable
PC must be set to the correct IP Address 192.168.150. 2 (see below:)
• PC or laptop can manually upload the latest Firmware to the MM860 if needed
• MM860 can be configured in a web browser using the default IP Address 192.168.150.111
• The MM860 Utility and latest firmware must be loaded onto the PC or Laptop before Installation
Ethernet
Home Network
Ethernet
or WiFi
Settings:
Network and Internet:
Change Adapter options:
Ethernet:
Internet Protocol Version 4 (TCP/IPv4):
Properties:
enter as shown....
192 . 168 . 150 . 2
255 . 255 . 255 . 0
. . .
IP address:
Obtain an IP address automatically
You can get IP settings assigned automatically if your network supports
this capability, Otherwise, you need to ask your network administrator
for the appropriate IP settings.
General
Internet Protocol Version 4 (TCP/IPv4) Properties
Use the following IP address:
Obtai
Subnet Mask:
Default gateway:
X
Send instructions to MM860
using the MM860 Utility or a
Home Automation system.
MM860 is connected to the
Network and the Internet.
PC can download the MM860 Utility
and Firmware from the Internet.
PC installs any needed MM860
Firmware updates and sets all
parameters with the Utility.
Optional:
Go to:
To set your PC to the correct IP Address: