Installation Guide

If the Auto Lowering Power Sensor (ALPS) feature is used, attach the

TV Power Cable as shown. The cable is plugged into the onboard

socket and quickly looped down away from the pinching area of the

TV Frame and the swivel portion of the mount. The cable should then

be looped again toward the TV with enough extra play to allow full

swivel to each side.

Keep all Cables

below pinch area

Reference Only: This is one possible configuration for the signal

cables. Each segment of the cables has extra length so that the

cables are not stressed or kinked when the mount is moved.

Ensure that cables do not get pulled or pinched between brackets

when the mount is raised.

Covers to assist with cable routing:

These covers can be used to hide cables

that are routed through the Housing.

Cable Cover {60} simply pulls open.

Access Cover {32} requires

removing two screws {18}.

MantelMount MM860 PAGE 13

Cable Ties

{15}

Anchor

{14}

To 110v

Wall Outlet

Attaching the TV Power Cable:

TV Power Cable using ALPS:

Power Cable