Installation Guide

PAGE 12 MantelMount MM860
UP
DOWN
RIGHT
LEFT
HOME
SET
M 2
M 1
Never allow children to play around, hang from,
or operate MantelMount. Property damage or
personal injury can occur.
Removing unwanted Tilt:
The TV should be fairly vertical in the up position and
parallel to the wall. If the TV is tilted downward, loosen
slightly the four bracket screws as shown.
Remove any tilt and then tighten the screws.
This unique safety feature of the MantelMount MM860 will
monitor the temperature above your fireplace at all times and
raise the mount automatically if the heat behind the TV rises
above 130ÛF (54ÛC).
The thermocouple sensor is located inside the
electronics housing.
Setting the Memory Positions:
Auto Raising Heat Monitor (ARHM):
!
CAUTION:
20 21
22
a. Setting the Memory Positions does not require
entering Program Mode.
b. Once all of the Hard Stops and Soft Stops are set,
jog the mount to the first desired viewing position.
c. On the Remote, Press the “SET” button and then
within 2 seconds press the “M1” button. The Memory
One position should be set.
d. Repeat for Memory Two position using the M2 button.