User Manual

38
Paint the Wall Covers {29} if desired.
39
PAGE 16 MantelMount MM700
(Steps 37 and 38 only apply if the cable box was installed
inside the area of the Wall Frame, which will require an
access hole through the Wall Cover.)
Measure carefully OR use transfer paint (similar to lipstick)
to transfer the box location onto the Wall Cover {29}.
Adjusting the Vertical Tilt Position:
The large screw inside the Lifting Mechanism will add or
remove a small amount of vertical tilt for the TV.
The screw is backed out to stop the TV from tilting.
Do not turn the screw in more than finger snug.Tighten
Locknut when finished.
36
37
Use 1.5 inch Hole Saw drill bit to cut a hole through
the Wall Cover {29} directly in the center of the
marked area.
Be careful not to damage the edge around the hole.