User Manual

Adjusting the Bottom Stop
Position:
Loosen the Locknuts and adjust
the Bottom Stop screws to the
desired stopping position.
There is one screw on each side of
the Lifting Mechanism. Make sure
to balance both sides evenly so
the TV is level in the DOWN
position.
Tighten both locknuts after the
adjustments are made.
Adjusting the Side Swivel Stop
Positions:
Loosen the Locknuts and adjust the
Swivel Stop screws to the desired
stopping positions, both left and
right.
Tighten both locknuts after the
adjustments are made.
Adjusting for Television weight: With Safety Bolt {20} in place,
use a socket wrench with an extension to adjust the long bolt inside
the Lifting Mechanism {35}. Turn the bolt clockwise (AS SHOWN
BELOW) to pull the Gas Springs down and increase the lifting force
for heavy TVs, or turn counter-clockwise for lighter TVs. This
adjustment can take several turns. (Reference Step 29.)
Adjust the bolt until the TV gently stays in the lowered position.
Move the TV up and down within the range below the Safety Bolt.
The TV should almost stay up against the Safety Bolt, but should be
easily lowered to the Bottom Stop.
35
33
Adjusting for Travel Stops and Television Weight:
Safety Bolt {20}
Safety Nut {21}
34
MantelMount MM700 PAGE 15