User Manual

Trace the Routing Box {27} (but not the tabs) for both
desired locations onto the wall along the edge of a stud.
Boxes must be mounted to studs.
Cut out both openings through the wall covering (drywall)
along the studs using a Keyhole Saw.
Attach one end of conduit to the box and install to stud
using Screws {19}. If the box is located within the
MantelMount Wall Frame {32} as shown below, then use
the inner tabs so that the box will protrude out to the Wall
Cover {29}. If the box is located outside the area of the
Wall Frame then break off the inner tabs and mount flush
to the wall using the outer tabs.
Feed the conduit through the other opening and cut the
other end of conduit to length using a hacksaw.
Install the second box to the stud using Screws {19},
and install a cover plate if available.
20 21
22
23
STUD
Note: Wall cut open for clarity
Signal Cables can usually be fed through the conduit simply
by pushing them through from the higher opening to the
lower opening.
Outer Tabs
Inner Tabs
MantelMount MM700 PAGE 11