Owners manual

30
Carefully hang the Television onto the TV Brace
making sure that all four hooks on the Vertical
Braces {31} engage the TV Brace.
DO NOT allow the Television to drop far enough
to cause the Lifting Mechanism {35} to hit the
mantle.
MantelMount comes pre-adjusted to reduce the
possibility of contacting the mantle, but you
should always be prepared to remove the
television at this stage to make the proper
correction.
If the Lifting Mechanism {35} appears to be too
close to the mantle, remove television. Go to
STEP 33 and make an adjustment to the Bottom
Stop position. Repeat this process until the
Lifting Mechanism is a safe distance from the
mantle when the TV is installed.
THIS STEP REQUIRES TWO PEOPLE
31
Center the TV on the TV Frame and check it with a level.
Carefully slide the TV sideways, if required, until it is
balanced and horizontal, up to a MAXIMUM OF 2 INCHES
left or right.
The TV would only need to be moved off-center if it has an
unbalanced weight. These are usually older, heavier TVs.
If the TV needs to be moved sideways and is visually too
much off-center above the mantel, remove the TV and
relocate the Wall Plate {32} an equal distance but in the
opposite direction of the TV to compensate.
32
PAGE 14 MantelMount MM700
C
L
2 inches
MAX
2 inches
MAX
Install 4 Screws {15} through the TV Brace {33}
and into the Vertical Braces {31}.
(Handle not shown)