User Manual

13
Customer Support 1.800.897.9755 x1 [e-mail]
Attach the TV Brace to the Lifting Arm.
Hang the TV Brace {33} onto the Lifting Arm {35}
and make sure it’s level when tightening the four
Leveling Screws {15}.
3.7
{33}
{35}
{15}
3.4
{17} {11}
Do not over-tighten Lag
Bolts, it can cause property
damage or injury. Tighten
only until the washers are
rmly against the Wall Plate.
WARNING
3.5
Insert Cable Tie Anchors
into Lifting Arm.
Insert two Cable Tie
Anchors {22} into
the front holes on
the lower part of
the Lifting Arm {35}.
Press rmly until at.
{35}
{22}
{22}
Use the included Cable Ties to attach cables.
Ensure Cable Ties {24} are sideways to the lower part of the
Lifting Arm {35}, making a gentle loop. The gure below
illustrates the recommended way to attach cables.
3.6
Cables must be
long enough to
accommodate the
extension and swivel
of the mount. Check
all ranges of motion
before tightening the
Cable Ties.
{24}
{35}
UP
PROFILE
VIEW OF
TV BRACE
{33}
UP
3.3
Drill four pilot holes.
Use a 7/32" drill bit to create a depth of 2.5"
(65mm), including wall covering.
Wall covering (drywall) must not exceed a
thickness of 5/8".
Cutout shown
for reference
Attach the Wall Plates
and Lifting Arm
(referred to as the
“mount” from this step
forward) onto the wall.
Install Lag Bolts {17} and
Washers {11} through
the Wall Plate {32} holes,
directly into the center
of the studs, using the
pilot holes drilled in
STEP 3.3.