User Manual

If the Lifting Arm is blocking a Wall Plate
hole you need to access:
Move the Wall Plates {32} to the left
or right of the desired position and
temporarily install it. Use four Lag
Bolts {17} to secure the Wall Plates to
the studs. This will allow you to pull the
Lifting Arm {35} down and install the
Safety Bolt (see STEP 4.1) in order to
access the blocked Wall Plate hole.
Then, remove Lag Bolts and reinstall
the mount in the desired position.
For assistance,
contact Customer
Support.
Attach Lifting Arm to Wall Plates.
If you arrived from STEP 2.5 then you can attach the Lifting
Arm {35} directly to the centers of the Wall Plates (32}.
If you arrived from STEP 2.6 (or optional STEP 2.7) then
you must align the center of the Lifting Arm to the marks
on the Wall Plates, while orienting the Upper and Lower
Wall Plate correctly.
Install four bolts {14} through the back channels of the
Wall Plates into the threaded holes of the Lifting Arm.
Tighten securely.
14
3.1
STEP 3
Attach Mount
to Wall
3.2
ALIGN HOLES WITH LOWER MARKS
ALIGN HOLES WITH UPPER MARKS
{35}
{14}
{14}
{32}
{32}
BACK CHANNEL
{35}
{32}
Verify positioning of the mount with stud(s).
Align the mount to the LOWER marked spots on the
wall and verify that the markings for the two UPPER
hole locations are accurate. Fine tune the upper marks if
necessary.
MM540 Installation Instructions 12