User Manual

2.7
OPTIONAL
Install the One-Way Swivel Kit if you want your TV to swivel 60° in only one direction and you are not mounting it above a
mantel.
30˚
60˚
C
E
N
T
E
R
R
I
G
H
T
L
E
F
T
STANDARD
30° BOTH
DIRECTIONS
OPTIONAL
60° ONE
DIRECTION
ONLY
3
0
˚
6
0
˚
{56}
{11}
{25}
{36}
MantelMount MM540 is designed to swivel 30°
left and 30° right. Most TVs will swivel all the
way to the mantel or wall within this amount of
standard swivel.
However, for situations where more swivel to
one side only is desired, such as in a corner or
on a side wall, the optional One-Way Swivel
Kit will provide 60° of swivel in either the
left or right direction (but not both). This
situation is recommended only for a mounting
situation that does not include a mantel.
Note: The Auto-Straightening feature does
not work with the One-Way Swivel Kit. The TV
will need to be manually straightened so it’s
parallel with the wall when raising it to the UP
position.
11
A. Remove the Swivel TV Plate {34}
from the Lifting Arm {35}. Save all of
the hardware for reassembly at the end
of this optional step.
B. Install both Side Swivel Plates {56}
onto the Lift Arm. The plates nestle
underneath the existing tabs. The
Screws {36} are installed in the center
hole of each Side Swivel Plate.
C. Re-attach the Swivel TV Plate onto
the desired side of the Side Swivel
Plates. Follow the reverse order that
each part was removed.
{34}
{35}
One-Way Swivel Kit Parts
{36} Screws {11} Washers {25} Nuts
{56} Side Swivel Plates
TV frame
shown for
reference only.
Customer Support 1.800.897.9755 x1 [e-mail]