Owners manual

Remove the
Safety Bolt
and store it for
future use.
For wiring inside the Wall Frame, use a Hole Saw drill bit to
cut a hole through a Wall Cover {57}. Be careful not to
damage the edge around the hole. For best results, support
the Wall Cover with scrap wood behind the drilling area.
Paint the Wall Covers {57} if desired and then snap them
onto the Wall Frame. The Safety Bolt can now be removed.
Adjusting the Vertical Tilt Position:
There are two sliding knobs, one on each side of the Tilt
Mechanism, used to set the tilt of the TV. Slightly loosen
the knobs and position the TV to the desired tilt, then
tighten the knobs.
The tilt will stay at the same angle while the mount is
raised and lowered, until it is manually changed.
32
33
Never release the handle before it is fully upright.
MantelMount is strongest in the top position, and
allowing it to slam closed can damage televisions.
Always control the lifting process.
!
CAUTION:
Never allow children to play around or operate
MantelMount. Property damage or personal injury
can occur.
!
CAUTION:
MantelMount MM540 PAGE 13