Owners manual

1
Use a Vertical Brace {31} to determine if your television
is a flat back or an irregular back. An irregular back will
require spacers and longer screws to fill any spaces
between the Vertical Brace and the TV.
The Braces must be parallel to your television screen.
Choose the correct screw diameter and length for the TV.
Hand-thread screw combination into the TV to ensure
there is adequate thread engagement without hitting the
bottom of threaded insert. Use only minimum amount of
spacers (if required).
2
3
Possible Screw Combinations shown with maximum
spacer usage (if spacers are required).
IMPORTANT INFORMATION: The Vertical Braces {31} are
a fixed distance (3 inches) higher than the bottom of the
Wall Plate {32}. This relationship can be used to calculate
unusual mounting situations such as centering the TV in
an alcove or mounting to a specific height on the wall.
4
Flat Back Irregular Back
Irregular Back
(Recessed Threads)
Spacers
Must leave a gap
in threaded
TV insert
7-10 threads
minimum
engagement
!
CAUTION:
Do Not use screws that are too long for the threaded
inserts of Television. This can damage internal components.
{02}
{01}
{10}
{10}
{10}
{10}
{11}
{11}
{11}
{12}
{12}
{10}
{12}
{10}
{12}
{12}
{12}
{12}
{12}
{12}
{12}
{12}
{12}
{03}
{05}
{04}
{06}
{08}
{07}
{09}
THREE INCHES
Fixed Distance
If you measure the distance from the
bottom of your TV (or Sound Bar) to the
bottom of the Vertical Braces {31} you
will automatically know the distance
from the bottom of your TV to the
bottom of the Wall Plate {32}.
You can use this information to install
the Wall Plate on the wall in order to
locate the height of your TV to any
specific height you desire.
Example: If the Vertical Braces are 6
inches higher than the bottom of your
TV, then the Wall Plate will be 3 inches
higher than the bottom of your TV when
the installation is complete.
If you are installing above a mantel,
then your installation must still have the
additional clearance for downward
motion stated in the chart in Step 9
M5
M6
M8
MantelMount MM340 PAGE 5