Owners manual

Adjusting the Bottom Stop

Position:

Loosen the Locknuts and adjust

the Bottom Stop screws to the

desired stopping position.

There is one screw on each side of

the Lifting Mechanism. Make sure

to balance both sides evenly so

the TV is level in the DOWN

position.

Tighten both locknuts after the

adjustments are made.

Adjusting the Side Swivel Stop

Positions:

Loosen the Locknuts and adjust the

Swivel Stop screws to the desired

stopping positions, both left and

right.

Tighten both locknuts after the

adjustments are made.

Note: If no swivel is desired, it may

be necessary to remove the locknuts

and re-attach them on the other side

of the Swivel Bracket so that the

Screws can be threaded out to their

maximum length.

Adjusting for Television weight: With Safety Bolt {20} in place,

use a socket wrench with an extension to adjust the long bolt inside

the Lifting Mechanism {35}. Turn the bolt clockwise (AS SHOWN

BELOW) to pull the Gas Springs down and increase the lifting force

for heavy TVs, or turn counter-clockwise for lighter TVs. This

adjustment can take several turns. (Reference Step 21.)

Adjust the bolt until the TV gently stays in the lowered position.

Move the TV up and down within the range below the Safety Bolt.

The TV should almost stay up against the Safety Bolt, but should be

easily lowered to the Bottom Stop.

Adjusting for Travel Stops and Television Weight:

Safety Bolt {20}

Safety Nut {27}

PAGE 12 MantelMount MM340