Owners manual

Carefully hang the Television onto the TV Brace

making sure that all four hooks on the Vertical

Braces {31} engage the TV Brace.

DO NOT allow the Television to drop far enough

to cause the Lifting Mechanism {35} to hit the

mantle.

MantelMount comes pre-adjusted to reduce the

possibility of contacting the mantle, but you

should always be prepared to remove the

television at this stage to make the proper

correction.

If the Lifting Mechanism {35} appears to be too

close to the mantle, remove television. Go to

STEP 25 and make an adjustment to the Bottom

Stop position. Repeat this process until the

Lifting Mechanism is a safe distance from the

mantle when the TV is installed.

THIS STEP REQUIRES TWO PEOPLE

Center the TV on the TV Frame and check it with a level.

Carefully slide the TV sideways, if required, until it is

balanced and horizontal, up to a MAXIMUM OF 2 INCHES

left or right.

The TV would only need to be moved off-center if it has an

unbalanced weight. These are usually older, heavier TVs.

If the TV needs to be moved sideways and is visually too

much off-center above the mantel, remove the TV and

relocate the Wall Plate {32} an equal distance but in the

opposite direction of the TV in order to compensate.

Install 4 Screws {15} through the TV Brace {33}

and into the Vertical Braces {31}.

MantelMount MM340 PAGE 11

2 inches

MAX

2 inches

MAX