Owners manual

Install the TV Brace {33} to the Lifting Mechanism {35}.
Level the TV Brace and tighten the 4 screws {15} and Locknuts {23}.
18
20 21
!
WARNING:
Do Not put hands into Lifting Mechanism without the
Safety Bolt and Safety Nut installed. The power of the
Lifting Mechanism can cause bodily injury!
19
Firmly pull down the bottom of the TV Brace until the Lifting
Mechanism is in a horizontal position. DO NOT HIT THE MANTLE!
The second person must insert the Safety Bolt {20} through the
Safety Hole in the Wall Bracket and install the Safety Nut {27}.
Slowly release the TV Brace.
The Lifting Mechanism should stay at a horizontal position.
THIS STEP REQUIRES TWO PEOPLE
PRE-SET THE LIFTING FORCE:
Turn the main bolt CLOCKWISE (while looking at the head of the bolt
from underneath) as shown to pull the Gas Springs DOWN for heavy
TVs. Rotate the bolt the other way for less lifting force for lighter TVs.
See the diagram below for a Pre-Set estimate for the Gas Springs. The
lightest lifting force is at the top, and the heaviest is down just below
the middle of the bolt threads.
UP
20 lbs
45 lbs
70 lbs
90 lbs
DO NOT adjust all the way to
the bottom. That position is
only to remove the Gas Springs.
Weight of TV
PAGE 10 MantelMount MM340
DO NOT pull
from the top