User Manual

6
1.7
1 inch MAX (25mm)
Install Brace Extenders
so that the Pull-Down
Handles sit 1" below
the TV (or sound bar).*
1" MAX
(25mm)
{30}
{30}
{30}
{23}
{23}
{18}
{18}
{18}
{18}
Attach Brace Extenders to the Vertical Braces.
Use Screws {18} and Nuts {23} to attach the Brace Extenders
{30} to the Vertical Braces {31}.
{31}
{31}
MM340 Installation Instructions
*MM340 requires
accessory for sound bar,
visit mantelmount.com.
OPTIONAL
If the lower VESA holes are less than 3" from the
bottom of the TV:
7
1.6
Connect the Vertical
Braces {31} through
the UPPER VESA
holes only, so that
the bottom of the
braces are between
3" to 10" from the
bottom of the TV.
*
If the only option is
to attach the Vertical
Braces to the UPPER
VESA holes through
a slot: 1) Hand-thread
the screw through
the slot; 2) slide the
Vertical Brace upward
until the screw meets
the bottom of the
slot; and 3) tighten
the screw.
You must attach the
Brace Extenders {30}
to the Vertical Braces
as described in STEP
1.7. However, you
must also attach the
LOWER VESA hole
through the Brace
Extender as shown.
SIDE VIEW
{30}
{31}
Attach the Vertical Braces to the back of TV.
Install the Vertical Braces {31} so that the bottoms of the
braces are between 3" to 10" from the bottom of TV,
*
centering the braces vertically as much as possible.
{31}
3 to 10
INCHES
*
1.5
SIDE VIEW
{31}
{31}
VERTICAL BRACES
MUST ALWAYS
BE INSTALLED
HIGHER THAN THE
BOTTOM OF THE TV.
If the lower VESA holes are less than
3" from the bottom of TV, go to
STEP 1.6; otherwise skip to STEP 1.7.
Hand-thread screw combination into the TV.
Ensure there is adequate thread engagement
without hitting the bottom of threaded insert.
1.4
Do not use screws that
are too long for the TV’s
threaded inserts because
it may damage internal
components!
MUST LEAVE
A GAP IN
THREADED
TV INSERT
MAXIMIZE THREAD
ENGAGEMENT FOR
STABILITY
AFTER ASSEMBLY
(ENLARGED)
{10}
{12}
CAUTIONCAUTION
TV SCREW
UPPER
VESA
HOLE
WITH
SCREW
IN PLACE
LOWER
VESA
HOLE
WITH
SCREW
IN PLACE
*
If installing this mount with a MantelMount RB100 Recess Box, the
bottom of the Vertical Brace must be 7"–10" from bottom of TV.
*
If installing this mount with a MantelMount RB100 Recess Box,
the bottom of the Vertical Brace must be 7"–10" from bottom of TV.