User Manual

15
Customer Support 1.800.897.9755 x1 [e-mail]
Adjust the Side Swivel Stop positions,
if necessary.
To keep your TV from bumping the
mantel or wall, loosen the Locknuts {23}
and adjust the Swivel Stop Screws to the
desired stopping left and right positions.
Tighten both Locknuts after the
adjustments are made.
If no swivel is desired, it may be
necessary to remove the Locknuts and
reattach them on the other side of the
Swivel Bracket so that the Screws can be
threaded out to their maximum length.
5.2
Never release the handle before the TV mount is fully upright.
(Don’t let it slam up!) MantelMount is strongest in the top
position, and allowing it to slam closed can damage televisions.
Always control the lifting process.
Remove the Safety Bolt and Safety Nut.
Store these parts for future use. The Safety Bolt {20}
and Safety Nut {27} are needed to remove the TV at any
time in the future.
5.4
{23}
TV BRACE
{20}
STORE SAFETY BOLT FOR FUTURE USE!
WARNINGWARNING
5.3
{23}
{35}
Adjust the Bottom Stop positions and
level the TV, if necessary.
To keep the TV from hitting the top of
the mantel or dropping too low, adjust
the Bottom Stop screws on each side of
the Lifting Arm {35}.
Loosen the Locknuts {23} and adjust
the Bottom Stop screws to the desired
stopping position, and tighten the
Locknuts.
Next, place a level on top of the TV. If
the TV is not level in the DOWN position,
adjust one of the bottom stop screws
until the TV is level.
Customer Support 1.800.897.9755 x1 [e-mail]