User Manual

Customer Support 1.800.897.9755 x1 [e-mail]
11
Attach the TV Brace to the Lifting Arm.
Hang the TV Brace {33} onto the Lifting Arm {35}
and make sure it’s level when tightening the four
Leveling Screws {15}.
3.7
{33}
{35}
{15}
3.4
{17} {11}
Do not over-tighten Lag
Bolts, it can cause property
damage or injury. Tighten
only until the washers are
rmly against the Wall Plate.
WARNINGWARNING
3.5
Insert Cable Tie Anchors
into Lifting Arm.
Insert two Cable Tie
Anchors {22} into
the front holes on
the lower part of
the Lifting Arm {35}.
Press rmly until at.
{35}
{22}
Use the included Cable Ties to attach cables.
Ensure Cable Ties {24} are sideways to the lower part of the
Lifting Arm {35}, making a gentle loop. The gure below
illustrates the recommended way to attach cables.
3.6
{24}
{35}
Cables must be
long enough to
accommodate the
extension and swivel
of the mount. Check
all ranges of motion
before tightening the
Cable Ties.
UP
PROFILE
VIEW OF
TV BRACE
{33}
UP
3.3
Drill four pilot holes.
Use a 7/32" drill bit to create a depth of 2.5"
(65mm), including wall covering.
Wall covering (drywall) must not exceed a
thickness of 5/8".
Cutout shown
for reference
Attach the Wall Plates
and Lifting Arm
(referred to as the
“mount” from this step
forward) onto the wall.
Install Lag Bolts {17} and
Washers {11} through
the Wall Plate {32} holes,
directly into the center
of the studs, using the
pilot holes drilled in
STEP 3.3.
Customer Support 1.800.897.9755 x1 [e-mail]