User Manual

STEP 3

Attach Mount

to Wall

If the Lifting Arm is blocking a Wall Plate hole you

need to access:

Move the Wall Plates {32} to the left

or right of the desired position and

temporarily install it. Use four Lag Bolts

{17} to secure the Wall Plates to the

studs. This will allow you to pull the

Lifting Arm {35} down and install the

Safety Bolt (see STEP 4.1) in order to

access the blocked Wall Plate hole.

Then, remove Lag Bolts and reinstall the

mount in the desired

position.

For assistance, contact

Customer Support.

Attach Lifting Arm to Wall Plates.

If you arrived from STEP 2.5 then you can attach the

Lifting Arm {35} directly to the centers of the Wall Plates

(32}.

If you arrived from STEP 2.6 then you must align the

center of the Lifting Arm to the marks on the Wall Plates,

while orienting the Upper and Lower Wall Plate correctly.

Install four bolts {14} through the back channels of the

Wall Plates into the threaded holes of the Lifting Arm.

Tighten securely.

3.1

3.2

ALIGN HOLES WITH LOWER MARKS

ALIGN HOLES WITH UPPER MARKS

{35}

{14}

{32}

BACK CHANNEL

{35}

{32}

Verify positioning of the mount with stud(s).

Align the mount to the LOWER marked spots on the

wall and verify that the markings for the two UPPER

hole locations are accurate. Fine tune the upper marks if

necessary.

MM340 Installation Instructions