Datasheet

LEAD ACID BATTERY CHARGER
◘ All values are based on the Standard ambient Temperature 25°C and Pressure 0.1Mpa.
◘ SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT PRIOR NOTICE
P.13 www.manson.com.hk
SBC-Series
12V 3-Stage IUoU Battery Charger
with High Efficiency Zero Voltage Switching Mode Design
Description
Features
Zero Voltage Switching design is used for good reliability,
high efficiency and energy saving for this series of high
current chargers.
The 3 Stage chargers have 4 specific settings for Wet , Cal-
Cal, AGM, GEL type battery to ensure fast, complete and
safe charging of your battery as required by the
manufacturers.
Soft Start Bulk Charge an automatic pre-bulk charging for
drained out battery. The charger gives 50% of full constant
current charge when it detects the battery is deeply
depleted at less than 9V terminal voltage. When battery
voltage rises to 11V the charger will resume the normal
constant full current Bulk, constant voltage Absorption and
Float charge stages.
In the Power Supply mode, the charger provides a constant
voltage to the external load connected to the battery and at
the same time fills up the battery without over charge. This
is ideal for caravan and other battery backup applications.
The Power Supply Mode output voltage is the same as the
selected Float Voltage.
The optional remote control panel shows the charging
stage, each battery voltage and turns the output on and off
as well.
A remote temperature sensor (ATS-5200) comes with every
charger. It adjusts the charging voltages with the changes in
ambient temperatures of the battery. This effectively
prevents over and under charging the battery in hot
summer days to cold wintry nights.
The charger has thermal control fan cooling (zero to full
speed) and dual charging banks.
The Over Voltage protection, the output of charger will
keep the voltage at less than 17.5V in the event of loss of
regulation in the charger to prevent damage to the battery
and connected load.
• Wide AC input tolerance 90V to 264V, 60/50Hz.
• Zero Voltage Switching (ZVS) circuit design for high
reliability& efficiency.
• 3 Stage (IUoU) switching mode lead acid battery charger
• 4 Battery Type (Wet / Cal-Cal / AGM / GEL) selections
• 3 Float Voltage Settings (13.2 / 13.5 / 13.8V) selections
• Battery can be connected to charger permanently
• Power Supply Mode selection
The power supply mode is ideal to charge battery with
load and keeps battery fully charged
• Automatic Soft Start Bulk Charge to ensure a safe and
gentle initial charging for deeply drained battery
• Remote temperature sensor (model ATS-5200) is
included .
It prevents over and under charging battery at high and
low ambient battery ambient temperature.
• Dual LED indicators for Bulk, Absorption, Float charge
stage; Fault, Power/Charger Mode and Power On.
• Power On-Off Switch
• Silent fan cool operation --- The thermal control cooling
fan with variable speed moves when ambient
temperature of charger at 45°C and off at 40°C.
• Protections to the charger --- Short circuit, Over Load,
Over temperature, Reversed Polarity (thermal fused)
• Protection to the battery and load --- by Output Over
Voltage Protection OVP