Technical Specifications

Form No. M6053 Printed in U.S.A. 4/07
© 2007 Mansfield Plumbing Products, LLC
® Pro-fit is a registered trademark
of Mansfield Plumbing Products, LLC.
Note: Measurements may vary 1/4" (6.4 mm +_)
Dimensions 32" x 59-3/4" x 19-1/4"
Material Acrylic, fiberglass reinforced
Construction Self-contained, pre-plumbed whirlpool bath
Pump Motor 1-1/4 HP, 1 phase, 120 volt, 60 HZ, 5.9 AMP,
Electrical Requirements 120 volt, 20 AMP, GFCI
Number of Jets Six
Air Volume Control Two
Water Capacity 42 gal. max., 27 gal. min.
(160 liters/103 liters)
Floor Loading 47 lbs./sq. ft. (229 kg/m
2
)
Shipping Weight 134 lbs. (61 kg)
Warranty Limited One Year
32"
59- 3/4 "
(1518 mm)
STD
Slope
1/4”
/Foot
(6 mm)/Foot
Suction
Air Switch
Drain
Jets
Air Control
8- 1/2 "
(216 mm)
54"
(1372 mm)
40"
(1016 mm)
16"
(406 mm)
32"
(813 mm)
17"
(432 mm)
26"
(660 mm)
19-1/4"
(489 mm)
17-3/4"
(451 mm)
15-1/4"
(387 mm)
Center Overflow
17-3/4"
(451 mm)
19-1/4"
(489 mm)
59-3/4"
(1518 mm)
18"
(457 mm)
15-3/4"
(400 mm)
SPECIFICATIONS
TECHNICAL INFORMATION
3260 ALTO
Rectangular Whirlpool or Bath
UPGRADES
These dimensions are nominal and are subject to change without notice.
When tested for compliance to the requirement of ANSI A112.19.7M and A112.19.8M for “Whirlpool
Bath Appliances” and ANSI Z124 for “Plastic Bathtub Units” the tested units are found to comply and
are acceptable for listing under the Terralab Engineers, Inc. follow-up service. Listed Number 15197.
Certified for permanent electrical supply connection only.
Factory Installed Nailing Flange
• Code approved, nailing flange option makes
watertight installation easy and secure.
Removable Apron - 5 ft. Model
• This upgrade provides quick and easy access
through removable apron to whirlpool pump
and interior parts.
Factory Installed In-line Heater
• A reliable, heating control upgrade maintains
water temperature at desired level and
operates when flow of water is detected in
the system. Features a standard plug for
easy electrical connection (GFCI: 120V, 20 amp dedicated circuit
required to power this heater).
Trim Upgrade
• This option allows an upgrade to Chrome or Everbrass (PVD) trim
including jets, intake, control and air control(s).
Lift & Turn Drain Kit
Chrome and Everbrass (PVD)
• The lift and turn drain kit provides simple and easy
draining of the bathtub.
Nailing Flange Kit
• Code approved kit featuring flange
material, sticky tape and instructions.
• Makes watertight installation easy
and secure.
Note: If a factory installed nailing flange is
added to a unit, add 1/8” to each side flanged.
Optional Removable Apron
PROFIT Specs 4/9/07 1:22 PM Page 26