Technical Specifications

Form No. M6041 Printed in U.S.A. 4/07
© 2007 Mansfield Plumbing Products, LLC
® Pro-fit is a registered trademark
of Mansfield Plumbing Products, LLC.
No apron available on this model
Pump locations are shown for clarity. STD-standard pump
location.ALT1-alternate pump location.
Note: If a factory installed nailing flange is added to a unit,
add 1/8" to each side flanged.
Note: Measurements may vary 1/4" (6.4 mm +_)
Dimensions 60" x 60" x 20"
Material Acrylic, fiberglass reinforced
Construction Self-contained, pre-plumbed whirlpool bath
Pump Motor 1.25 HP, 1 phase, 120 volt, 60 HZ, 5.9 AMP
Electrical Requirements 120 volt, 20 AMP, GFCI
Number of Jets Six
Air Volume Control Two
Water Capacity 70 gal. max., 42 gal. min.
(265 liters/159 liters)
Floor Loading 47 lbs./sq. ft. (229 kg/m
2
)
Shipping Weight 146 lbs. (66 kg)
Warranty Limited One Year
Drain
Air Switch
Air Control
Jets
Suction
ALT1
STD
60"
(1524 mm)
Slope
1/4”
/Fo
ot
(6 mm)/Foot
60"
(1524 mm)
39"
(991 mm)
41"
(1524 mm)
27"
(686 mm)
46"
(1168 mm)
35-5/8"
(905 mm)
35-5/8"
(905 mm)
Centerline Overflow
84"
(2134 mm)
18-1/2"
(470 mm)
17"
(432 mm)
20"
(508 mm)
SPECIFICATIONS
TECHNICAL INFORMATION
6060 DL
Corner Whirlpool or Bath
UPGRADES
These dimensions are nominal and are subject to change without notice.
When tested for compliance to the requirement of ANSI A112.19.7M and A112.19.8M for “Whirlpool
Bath Appliances” and ANSI Z124 for “Plastic Bathtub Units” the tested units are found to comply and
are acceptable for listing under the Terralab Engineers, Inc. follow-up service. Listed Number 15197.
Certified for permanent electrical supply connection only.
Factory Installed In-line Heater
• A reliable, heating control upgrade maintains
water temperature at desired level and
operates when flow of water is detected in
the system. Features a standard plug for
easy electrical connection (GFCI: 120V, 20 amp dedicated circuit
required to power this heater).
Nailing Flange Kit
• Code approved kit featuring flange
material, sticky tape and instructions.
• Makes watertight installation easy
and secure.
Trim Upgrade
• This option allows an upgrade to Chrome or Everbrass (PVD) trim
including jets, intake, control and air control(s).
Lift & Turn Drain Kit
Chrome and Everbrass (PVD)
• The lift and turn drain kit provides simple and easy
draining of the bathtub.
Factory Installed Nailing Flange
• Code approved, nailing flange option makes
watertight installation easy and secure.
PROFIT Specs 4/9/07 1:22 PM Page 4