Technical Specifications

Form No. M5078 Printed in U.S.A. 2/07
© 2007 Mansfield Plumbing Products, LLC
® Swirl-way is a registered trademark
of Mansfield Plumbing Products, LLC
.
Dimensions 42" x 68" x 23-1/2"
Material Acrylic, fiberglass reinforced
Construction Self-contained, pre-plumbed whirlpool bath
with heat-bent rigid PVC pipe, mounted on a
pre-leveled thermoformed, drip pan base
Pump Motor 2 HP, Ten speed, 120 volt, 60 HZ, 13.5 AMP
Electrical Requirements Two, 110 volt, 20 AMP, separate circuits
Required with Class A GFCI protection
Electrical Requirements Lux.-Sen.: Two separate 120 volt, 20 AMP, GFCI
protected circuits
Basic: One separate, 120 volt, 20 AMP, GFCI outlet
Number of Jets Fourteen
Air Volume Control Two
Water Capacity 80 gal. max., 60 gal. min.
(303 liters/227 liters)
Floor Loading 47 lbs./sq. ft. (229 kg/m
2
)
Shipping Weight 180 lbs. (82 kg)
Warranty Limited Ten Year
68"
(1727 mm)
Suction
Drain
Mood
Light
Slope
1/4
"/Foot
Jets
60"
(1524 mm)
48"
(1219 mm)
32"
(813 mm)
21"
(533 mm)
42"
(1067 mm)
21"
(533 mm)
23-1/2"
(597 mm)
21-1/2"
(546 mm)
65"
(1651 mm)
20-1/2"
(521 mm)
39"
(991 mm)
Air Controls
Overflow
Centerline
STD
ALT1
9-1/4"
(235 mm)
Luxury Package
• SensaSelect™ 5 button control
• 2 HP 10-speed pump
• Remote control
• Exclusive custom grab bars
• Pillow
• Infusion™ 2 Chromatherapy system
• In-Line heater
• Metal trim upgrade
Basic Package
• SimpleTouch™ 3 button control
• 2 HP single speed pump
• Exclusive custom grab bars
• Pillow
• Color-Match trim
SPECIFICATIONS
TECHNICAL INFORMATION
HAMPTON OV
Oval Whirlpool or Bath
FEATURES & UPGRADES
These dimensions are nominal and are subject to change without notice.
When tested for compliance to the requirement of ANSI A112.19.7M and A112.19.8M for “Whirlpool
Bath Appliances” and ANSI Z124 for “Plastic Bathtub Units” the tested units are found to comply and
are acceptable for listing under the Terralab Engineers, Inc. follow-up service. Listed Number 15197.
Certified for permanent electrical supply connection only.
Sensory Package
• SensaSelect™ 5 button control
• 2 HP 10-speed pump
• PowerPillow™ neck jet pillow
• Remote control
• Exclusive custom grab bars
• Pillow
• Infusion™ 2 Chromatherapy system
• In-Line heater
• Metal trim upgrade
No apron available on this model
Pump locations are shown for clarity. STD-standard pump location.
ALT1-alternate pump location.
Note: Install this product according to the installation guide.
Fixture dimensions are nominal and conform to
tolerances in ASME Standard A112.19.2
Basic Options
• Infusion™ 2 Chromatherapy system
• 1500 watt in-line water heater
• Metal trim upgrade
• Cable drain in CM, CH, EB & BN
Flyer Set C 0107.qxd 2/27/07 2:50 PM Page 18