Technical Specifications

Form No. M5017 Printed in U.S.A. 2/07
© 2007 Mansfield Plumbing Products, LLC
® Swirl-way is a registered trademark
of Mansfield Plumbing Products, LLC
.
Dimensions 47" x 70" x 20-1/4"
Material Acrylic, fiberglass reinforced
Construction Self-contained, pre-plumbed whirlpool bath
with heat-bent rigid PVC pipe, mounted on a
pre-leveled thermoformed, drip pan base
Pump Motor 2 HP, Ten-speed, 120 volt, 60 HZ, 13.5 AMP,
pre-mounted
Electrical Requirements Lux.-Sen.: Two separate 120 volt, 20 AMP, GFCI
protected circuits
Basic: One separate, 120 volt, 20 AMP, GFCI outlet
Number of Jets Sixteen
Air Volume Control Tw o
Water Capacity 75 gal. max., 50 gal. min.
(285 liters/190 liters)
Floor Loading 47 lbs./sq. ft. (229 kg/m
2
)
Shipping Weight 155 lbs. (70 kg)
Warranty Limited Ten Year
Overflow
Centerline
17-1/2"
(444 mm)
70"
(1778 mm)
35"
(889 mm)
12"
(305 mm)
42"
(1067 mm)
61"
(1549 mm)
25"
(635 mm)
33-3/4"
(857 mm)
47-1/2"
(1206 mm)
Mood Light
Air Controls
Drain
Jets
Slope
Suction
1/4
"/Foot
STD
ALT1
42"
(1067 mm)
47"
(1194 mm)
70"
(1778 mm)
66"
(1676 mm)
18"
(457 mm)
20-1/4"
(514 mm)
Luxury Package
• SensaSelect™ 5 button control
• 2 HP 10-speed pump
• Remote control
• Pillows
• Infusion™ 2 Chromatherapy system
• In-Line heater
• Metal trim upgrade
Basic Package
• SimpleTouch™ 3 button control
• 2 HP single speed pump
• Pillows
• Color-Match trim
SPECIFICATIONS
TECHNICAL INFORMATION
WAVERLY
Oval Whirlpool
FEATURES & UPGRADES
These dimensions are nominal and are subject to change without notice.
When tested for compliance to the requirement of ANSI A112.19.7M and A112.19.8M for “Whirlpool
Bath Appliances” and ANSI Z124 for “Plastic Bathtub Units” the tested units are found to comply and
are acceptable for listing under the Terralab Engineers, Inc. follow-up service. Listed Number 15197.
Certified for permanent electrical supply connection only.
Sensory Package
• SensaSelect™ 5 button control
• 2 HP 10-speed pump
• PowerPillow™ neck jet pillow
• Remote control
• Pillows
• Infusion™ 2 Chromatherapy system
• In-Line heater
• Metal trim upgrade
No apron available on this model
Pump locations are shown for clarity. STD-standard pump location.
ALT1-alternate pump location.
Note: Install this product according to the installation guide.
Fixture dimensions are nominal and conform to
tolerances in ASME Standard A112.19.2
Basic Options
• Infusion™ 2 Chromatherapy system
• 1500 watt in-line water heater
• Metal trim upgrade
• Cable drain in CM, CH, EB & BN
Flyer Set A 0107.qxd 2/27/07 3:27 PM Page 20