Warranty Information
For further information regarding Mannington products, visit www.mannington.com or call our customer care team at 800-356-6787.
Copyright © 2018 Mannington or its affiliates. All rights reserved.
3
Adura
®
Flex
Warranties and Floor Care
MANNINGTON FLOOR CARE INSTRUCTIONS
• Use doormats outside each entrance to your home to prevent
dirt, sand, grit or other substances such as oil, asphalt and
driveway sealer from being tracked onto your floor. Use mats
labeled non-staining on your floor.
• To minimize staining from asphalt tracking, we suggest you use
latex-based driveway sealer on your driveway.
• Close your curtains or blinds where extreme sunlight hits the
floor. Like with all floor coverings, protect the finished
ADURA®Flex installation from exposure to direct sunlight. A
combination of heat and sunlight can cause most home
furnishings to fade or discolor. Avoid exposure to direct sunlight
for prolonged periods. During peak sunlight hours, the use of
blinds or drapes is recommended. Prolonged direct sunlight can
result in discoloration and excessive temperatures may cause
floor expansion (which may cause buckling) or delamination.
• Support furniture with wide-bearing, non-staining floor
protectors. The protectors should be at least one-inch in
diameter, made of non-pigmented hard plastic, and rest flat on
the floor. Non-staining felt protectors are also acceptable. Casters
with a minimum 3/4” flat surface width or floor protectors are
recommended for all movable furniture. Make sure any metal
protectors are rust-proof. Replace your narrow dome furniture
rests with wide-bearing ones.
• If you need to move heavy furniture and/or appliances across the
floor, always use strips of wood or hardboard runways to protect
the floor. Always use runways even if you have an appliance dolly
or even if heavy objects are equipped with wheels or rollers.
• Sweep your floor regularly (at least once per week).
• Prevent stains by wiping up spills immediately.
• Occasional cleaning with Mannington UltraClean™ (lightly misted)
and a microfiber mop (or cloth) or mopping with Mannington
Award Series® Rinse-Free Cleaner is recommended when dirt
builds up and sweeping alone is not sufficient. Use a solution of 2
to 3 capfuls of Award Series® Cleaner (or clear, non-sudsy
ammonia) in one gallon of warm water. Use of more than the
recommended amount of cleaning solution may leave a dulling
film. Do not use soap or detergent products as they will leave a
dulling film. Rinsing is not required when using Mannington
Award Series® Rinse-Free Cleaner, but if time permits, rinsing will
provide the best care.
• ADURA®Flex is a low-gloss floor; use polish or “mop and shine”
products only if you wish to make the floor shiny.
• After several applications of polish for a high-shine floor, an
occasional stripping and reapplication of polish may be
necessary. We recommend the use of Mannington Award
Series® Heavy Duty Cleaner and Stripper. After thorough
cleaning, rinsing and drying, we recommend applying
Mannington Award Series® High-Gloss Polish to restore the shine.
Do not use wax. Do not buff. High traffic areas may require more
than one application of polish. Allow polish to dry “tack-free”
between coats.
For complete instructions regarding the proper use of
Mannington floor care products, refer to the package labels.
Caution: Adura Floors can be slippery when they become wet. Use
extreme caution when walking on a wet floor.
The overall stain resistance of ADURA®Flex is excellent, and most
spills will wipe off quickly and easily with a clean, white cloth.
Removing certain substances may take a little extra effort, as
outlined in the chart below.
• Start with the first step listed.
• Only do steps necessary to resolve the problem.
• Always use a clean, white cloth for wiping up stains and turn it
frequently to avoid spreading the stain.
• Rinse with clean water and allow area to dry between steps.
• If stain removal causes a change in gloss level, apply polish per
recommended guidelines.
Maintenance Chart
Stain/Problem Recommendation
Food, Beverages
If a substance is gummy, scrape off with a
dull knife. Clean using Mannington
UltraClean
™
and a soft nylon pad or soft
bristle brush. Saturate a clean, white cloth
with bleach* solution, cover stain and allow
to stand for no more than 1 hour.
Tar, Oil, Asphalt,
Paint (Oil Based)
Scrape excess substance off with a dull
knife. Clean using UltraClean
™
and a soft
nylon pad or soft bristle brush.
Scuffs, Marks,
Scratches
Wipe with a clean, white cloth dampened
with lighter fluid, painter’s naphtha or
isopropyl alcohol.*
Minor Cuts,
Burns
Limit traffic over damaged area, cover with
masking tape, contact your retailer or
Mannington for advice.
Rust
Clean using Mannington Award Series®
Heavy Duty Cleaner and Stripper and a soft
nylon pad or soft bristle brush. Saturate a
clean, white cloth with bleach** solution,
cover stain and allow to stand for no more
than 1 hour.




