Specifications

66
For complete equipment specifications visit our website at www.hobartcorp.com
Warewashing & Waste Equipment
STANDARD FEATURES
Standard insulated hinged doors on Hobart’s CLeR Warewasher
provide full and unrestricted access into the chamber. The insu-
lated doors emit 76% fewer watts of energy into a room. Energy
Recovery system captures the energy from the exhaust air to
elevate the temperature of the cold water supply to 110° to feed
the booster heater.
The Energy Recovery system captures escaping heat and steam
from the exhaust air and uses a heat exchanger to recycle it into
energy. This free energy is used to preheat the incoming water
supply before it enters the booster heater. The cold ground
temperature water passes through a heat exchanger positioned
directly in line with the machine’s unload exhaust system to
capture the energy from the exhaust air and ware leaving the
machine to elevate the temperature of the water to 110° before it
enters the booster heater.
Microprocessor controls include exclusive features such as
Energy Saver mode, dirty-water indicator, low-temperature alerts,
delime notification and a conveyor dwell mode for an endless
wash zone of heavily soiled ware.
Thermal layered curtains are designed to improve temperature
retention by an additional 2° to 3°F.
Computational fluid dynamic designed wash system ensures
proper alignment and improved results with a full 20 inches of
separation between the wash and the rinse zone.
Rapid Return drive system improves wash and rinse results as
well as reduces the stress on the drive mechanism with more
even throughput.
Pump intake screen not only prohibits large debris from getting
into the pump but also the drain as well. The new chamber design
provides 67% less interior baffling and wash pipes to clean
around.
The improved one-piece strainer pan simplifies the cleanup
process. A new exclusive above the waterline design for the pump
and drive motor increases reliability. The new 23-gallon prewash
tank allows for more food soil to be absorbed before refilling.
When electric heat is specified on any automatic conveyor dish-
washer, disconnect switches are recommended for each power
circuit connected to dishwasher. These disconnect switches are
NOT furnished by Hobart and should be installed in the power
circuits ahead of the dishwasher by the electrical contractor at
the time of installation.
For Selection Factors and Ordering Data – see Page 00.
AUTOMATIC RACK CONVEYOR DISHMACHINES –
CLe R Series
Listed by UL, Certified by NSF, and meets
requirements of ASSE Standard No. 1004
CL44eR
MODEL NO.
CL44eR
Machine Ratings (Mechanical) See 1 Page 70
 3BDLTQFSIPVS
3
⁄
4
Y
3
⁄
4
 202
Conveyor Speed – feet per minute 5.6 max.
 %JTIFTQFS)PVS"WFSBHFQMBUFTQFSSBDL 3,636
 (MBTTFTQFS)PVS"WFSBHFQFSSBDL 7,2 72
Floor Spaceo5BCMFUP5BCMF*ODIFT 44
Overall Dimensionso)Y8Y%*ODIFT
70
1
⁄
4
x 45
1
⁄
4
x 30
1
⁄
4
Motor – See 2 Page 70)1
Conveyor Drive
2
1
⁄
6
Number of Tanks 1
Tank Capacity – Gallons 23
Pump Capacity – See 3 Page 70
Gallons per Minute – Weir Test 165
Heating Equipment – See 4 Page 70o'PSLFFQJOH
power wash and or power rinse water hot)
 (BT#VSOFSTXJUI/BUVSBM(BTo#56QFSIS 78,000
Electric Heating Unit – Size Used
Regulated
15 KW
Rinse – See 5 Page 70 – Minutes operated during
hour of maximum operation 60
Final Rinse Flow – Gals. per min.
At 15 PSI Flow Pressure
1.8
At 20 PSI Flow Pressure 2.1
Final Rinse Flow – Gals. per hr. – MAXIMUM
At 15 PSI Flow Pressure 108
At 20 PSI Flow Pressure 126
Rinse – 20 PSI Flow Pressure
Gal./Rack
Hot Water Sanitizing –
Chemical Sanitizing
.62 - 180°F – .62 - 140°F
Steam Consumption – Pounds per hr. –
 ."9*.6."QQSPYMCTQFSISCPJMFS
 )1#)1%JTIXBTIFSCBTFEPO14*TUFBN
and on customer supplying final rinse water at
180°F maximum
65 lbs./hr.
Steam Booster, if used on 20 PSI steam –
Pounds per hr. - 20 PSI water flowing –
130°F entering water raised to 180°F min.
60 lbs./hr.
Exhaust Requirements – Cubic feet per minute
 $'.
Entrance End
200
Discharge End 150
Peak Rate of Drain Flow – Gallons per minute
 (1.*OJUJBMSBUFXJUIGVMMUBOL
38
Shipping Weight Crated – Approximate 703 lbs.