User Manual

MAINS CONNECTIONS
Your TNT has been factory set to the correct mains voltage for your country. The voltage
setting is marked on the serial badge, located on the rear panel. Check that this complies
with your local supply.
Export units for certain markets have a moulded mains plug tted to comply with local
requirements. If your unit does not have a plug tted the colored wires should be connected
to the appropriate plug terminals in accordance with the following code.
GREEN/YELLOW EARTH
BLUE NEUTRAL
BROWN LIVE
As the colors of the wires in the mains lead may not correspond with the colored marking
identifying the terminals in your plug proceed as follows;
The wire which is colored GREEN/YELLOW must be connected to the terminal in the plug
which is marked by the letter E or by the safety earth symbol or colored GREEN or GREEN
and YELLOW.
The wire which is colored BLUE must be connected to the terminal in the plug which is
marked by the letter N or colored BLACK.
The wire which is colored BROWN must be connected to the terminal in the plug which is
marked by the letter L or colored RED.
DO NOT CONNECT/SWITCH ON THE MAINS SUPPLY UNTIL ALL OTHER
CONNECTIONS HAVE BEEN MADE.
Note: This unit has been factory wired for your country. If you plan to take the unit to
countries with a different mains voltage you will need to send the unit to Manley Labs for
the correct power transformer - or use AC voltage converters.
24