Owners Manual

29
SPECIFICATIONS
MIC PRE SECTION:
Frequency Response: +/- 1 dB 10 Hz to 40 kHz
Gain range +60 to 0 (another +/- 20dB using the OUTPUT Level giving 80 dB total)
Noise Floor (150 ohm source) -85 dB (A Weight) -X 20 Hz to 20 kHz (ref to +4 dBm)
Equivalent Input Noise
Input Impedance approximately 2000 ohms
Maximum Input : 1.5% THD +20 dBm (typical headroom 20 -20K)
THD & Noise (1kHz, 30mV in, 0VU out) .1%
Instrument Input (DI) Impedance 100k ohms with jack in all the way or 10 meg with jack 1/2 way in.
(DI) Gain range +40 to -20
LINE & LIMITER SECTION:
Frequency Response ` 10 Hz to 40 kHz
THD & Noise (1kHz, +4 dBu in, +4 dBu out) .03% (no limiting)
Maximum output level +28 dBu (20 to 20K, 100K load), +24 dBm (600 ohm load)
+22 dBu (-10 dBv output)
Gain range -20 to +20 using the OUTPUT Level control
ELOP Threshold +4 to +30
FET Threshold +4 to +30
Maximum Limiting ELOP 25 dB, FET 15 dB, total 40 dB
Ratio (see following page for graph) ELOP 10:1, FET 5:1
ELOP Attack time (complex) 5 mS
ELOP Release time (complex) 500 mS (fast then slow for final 2 dB)
FET Attack times VF = .1 mS, F = 3 mS, M = 10 mS
FET Release times 10 mS to 2 sec
VU METER (large Sifam) 3 MODES, Input, Output (A/D input), Gain Reduction (GR)
3 Attenuators, 0 (+4 dBu), -3 (+7dBu) -6 (+10 dBu)
LED METER 26 multi-color LEDs per, multi-function
Shows Peak, Peak Hold, Fet GR, Opto GR, and combinations
Peak Attack time = .1 mS, Release 250 mS
MANLEY SLAM!