Owners Manual

MAINS CONNECTIONS
Your SLAM! has been factory set to the correct mains voltage for your country. The voltage
setting is marked on the serial badge, located on the rear panel. Check that this complies with
your local supply.
Export units for certain markets have a moulded mains plug fitted to comply with local re-
quirements. If your unit does not have a plug fitted the coloured wires should be connected to
the appropriate plug terminals in accordance with the following code.
GREEN/YELLOW EARTH
BLUE NEUTRAL
BROWN LIVE
As the colours of the wires in the mains lead may not correspond with the coloured marking
identifying the terminals in your plug proceed as follows;
The wire which is coloured GREEN/YELLOW must be connected to the terminal in the plug
which is marked by the letter E or by the safety earth symbol or coloured GREEN or GREEN
and YELLOW.
The wire which is coloured BLUE must be connected to the terminal in the plug which is
marked by the letter N or coloured BLACK.
The wire which is coloured BROWN must be connected to the terminal in the plug which is
marked by the letter L or coloured RED.
DO NOT CONNECT/SWITCH ON THE MAINS SUPPLY UNTIL ALL OTHER
CONNECTIONS HAVE BEEN MADE.
Note: There is a mains voltage change-over switch that allows the SLAM! to be easily
configured for 117V or 220V wall voltage. This switch is on the remote power supply and
one needs a flat head screwdriver to change it. This should only be done with the IEC
power cable removed. DO NOT set it for the wrong voltage as this could damage the unit.
Also the fuse should change when one changes the change-over switch. The SLAM! uses a
2 Amp SLO-BLO fuse for 117 volts and a 1 amp SLO-BLO fuse for 220 volts. A 2 amp
fuse for 220 volts prevents the intended protective value of a fuse. A 1 amp fuse for 117
volts will probably blow on power-up.
28