Owner`s manual

Jumpers marked P-04, P-05, P-06 are used to change from the default mode where OUT 2 and OUT

3 alternate interlocked or are individually (push on, push off) controlled. To set OUT 2 and OUT 3

to individually (push on, push off) mode refer to drawing for jumper configuration.

There are 3 sets of 8way dip switches, 2 on the Wave logic board marked SW-015 and SW-016 and

one in the remote. All 3 sets must be set identically for proper operation. These are used to set the

"address" function of the remote control, IR receiver and front panel. They should only be changed

in the unlikely scenario where one of your other remote controls and the Wave clash. They allow the

Wave to use a different remote control "address". All 3 should be set the same unless for some

reason you want the front panel buttons disabled. In that case, change SW-015 to be unique.

REAR VIEW

BACK OF FRONT PANEL

DIP SWITCHES

DEFAULT MODE

P-04,P-05,P-06

"FACTORY DEFAULT"

OUT 2,OUT 3 ALTERNATE

SW-015

SW-016

12 3

P-06 BLACK

P-04 RED

P-05 BLUE

"DRAWING NOT TO SCALE"

DIP SWITCHES

DEFAULT MODE

P-04,P-05,P-06

OUT 2, OUT 3

INDIVIDUALLY

CONTROLLED

SW-015

SW-016

12 3

P-06 BLACK

P-04 RED

P-05 BLUE

dip switchesdip switches

dip switches

*See notes below