Troubleshooting guide

Installation and Service Manual

USER MAINTENANCE

MONTHLY CLEANING

CLEANING AND SANITIZING OF THE DISPENSER

Note: Sanitize the dispenser at initial start-up in addition to monthly sanitizing.

Mix a solution of mild, nonabrasive detergent to clean the dispenser bin and components. Using a clean cloth or a

soft bristle brush, clean the following dispenser parts:

• Cold plate

• Ice storage bin, including the

• Agitator

• Agitator Pin

• Bin liner & support

• Drainpan support bracket

• Auger

• Auger tube

• Auger transition

• Ice chute outer bracket

• Ice chute

• Ice chute door

• Ice chute lock

• Ice chute spout

• Paddle wheel

• Paddle wheel bushing

• Paddle wheel area

Rinse all parts in clean, running water. Mix a sanitizing

solution of ¼ ounce liquid, unscented laundry bleach

(5.25% Cl Na O concentration) for each gallon of water,

to supply 100 PPM of available chlorine. Using this so-

lution and a clean cloth or soft bristle brush, clean the

dispenser parts listed above. Allow parts to air-dry then

reassemble.

Scheduled cleaning must be in compliance with local health codes. This cleaning schedule is a

recommendation. Follow cleaning and sanitizing instructions found in the Manitowoc manual to

clean and sanitize the icemaker. The LP-3 drainpan and splash panel must be removed before

cleaning the icemaker.