Troubleshooting guide

Installation and Service Manual

OPERATION

EQUIPMENT

The LP-3 is a 10 flavor ice and beverage dispenser, with

the ice storage bin located below the counter top level. A

drink tower extends 19” above the counter top level. The

LP-3 is designed to fit into a 42.5” wide by 30.38” deep

space, and can be counter mounted (like a conventional

drop-in unit), or arranged as a stand alone with cosmetic

stainless panels.

Within the 19” drink tower is an optional 1000 lb/day re-

mote ice cube maker, especially designed by Manitowoc

for this application.

Beverage cooling is accomplished by means of a cold

plate positioned below the storage bin, and the unit can

include an internally mounted or externally mounted car-

bonator system. In order to allow any valve to dispense

carbonated or non-carbonated beverages, two Servend

Flex Manifolds are incorporated into the tower.

Ice is dispensed from the storage bin by means of the paddle

wheel into an auger which raises the ice to the top of the

tower where it is dispensed by means of a rocking chute.

The drink tower is enclosed by 5 panels, one on each

side and back, as well as a splash panel in front below

the valves, and a top panel. Safety switches will disable

the ice dispensing circuit when either the top panel or

the splash panel are removed. The drive motors for agi-

tation and auger ice lifting are mounted using locking pins,

and thus can be removed for maintenance and cleaning

without tools. Access is provided for in place cleaning of

the ice maker. The ice maker water valve, water pan, cur-

tain, and water pump can all be removed for service and

cleaning without removing the ice maker itself.

The LP-3 can be built in either a left hand or right hand ice

dispense arrangement. In the right hand configuration wa-

ter/syrup lines from the BIB pumps are brought in to the

unit at the lower left, drains, electrical and refrigerant lines

on the right.

Drain hoses are provided for the waste water from the

cuber, spillage and melt water from the drain pan, and

melt water from the storage bin and auger. A water sup-

ply line is necessary for the ice maker and beverage sys-

tem, each connecting to a

” ID. beverage tube.