Installation, Operation, and Maintenance Manual

Maintenance Section 4
14
Part Number 000007646 11/10
Cleaning and Sanitizing
MONTHLY SANITIZING PROCEDURE
1. Remove the front panel, paddle wheel, ice chute and
door assembly.
2. Mix a solution of 3 ounces (100 ml) Manitowoc
cleaner per 1 gallon (4 liters) plain tap water.
3. Carefully clean all parts removed from inside the bin
with this cleaner. Clean the dispenser bin, door
assembly, and ice chute.
4. Rinse all cleaned parts with fresh, running tap water.
5. Mix a solution of 3 ounce (90 ml) Manitowoc
sanitizer with 4 gallons (15 liters) plain tap water.
6. Sanitize each part washed in the previous step with
this sanitizer solution. Sanitize and re-assemble in
this order:
Paddle wheel
Agitator
Paddle wheel pin
Ice chute assembly
Scrap ice tray
Front panel
7. Do not rinse dispenser parts after they are sanitized.
Allow parts to air dry.
8. After all dispenser parts are replaced, restore power
to the dispenser.
9. Turn the ice machine on.
10. Allow the ice machine to begin filling the dispenser.
11. After three batches are in the dispenser, test the
dispenser operation.
Assembly
RE-INSTALLING THE PADDLE WHEEL GUARD
When re-assembling the rocking chute/door, the paddle
wheel guard is installed inside the ice dispense snout.
When the paddle wheel guard is placed in the snout, its
top hinge is snapped into mounting holes on both sides
of the snout.
When the paddle wheel guard is correctly installed, the
paddle wheel guard will swing outward toward the front
of the chute, allowing ice to flow out of the chute.
If incorrectly installed, the paddle wheel guard will not
swing outward and ice delivery is blocked.
Correct Installation
If you press your finger forward against the paddle wheel
guard, the paddle wheel guard does not swing back
open.
!
Warning
Electric Shock Hazard
Unplug unit before servicing or cleaning.
Paddle
Wheel
Guard