Specifications

Maintenance Section 4

4-8

Part Number 000000345

Ice Thickness Probe

A. Compress the hinge pin on the top of the ice

thickness probe.

Ice Thickness Probe Removal

B. Pivot the ice thickness probe to disengage one

pin then the other. The ice thickness probe can

be cleaned at this point without complete

removal. Follow Step C for complete removal.

C. Disconnect the ice thickness control wiring from

the control board.

Water Distribution Tube

NOTE: Distribution tube thumbscrews are retained by o-

rings to prevent loss. Loosen thumbscrews but do not

pull thumbscrews out of distribution tube.

Water Distribution Tube Removal

A. Remove outer half of distribution tube by

loosening the four (4) thumbscrews (o-rings

retain thumbscrews to distribution tube).

B. Pull inner half of water distribution tube forward

to release slip joint from water pump tubing

connection.

Warning

Disconnect the electric power to the ice machine at

the electric service switch box.

SV3135

COMPRESS

HINGE PIN TO

REMOVE

Warning

Removing the distribution tube while the water

pump is running will allow water to spray from ice

machine. Disconnect the electrical power to the ice

machine and dispenser at the electric service switch

box and turn off the water supply.