Specifications

Maintenance Section 4
4-4
Part Number 000005546 12/09
PROCEDURE TO CLEAN HEAVILY SCALED FLAKE ICE MACHINES
Step 1 Set the toggle switch to the OFF position and
remove all ice from the bin.
Step 2 Remove the 2 thumbscrews and white plastic
panel from the interior back wall of the bin.
Step 3 Disconnect water supply line at float valve quick
disconnect by depressing stainless steel lever.
Step 4 Refer to chart below:
Premix cleaner with lukewarm water in a non-
metallic container.
Step 5 Remove all water from the evaporator and water
reservoir. Start an ice making cycle by moving the toggle
switch to the ICE position. Water will flow through the
water dump valve and down the drain for 45 seconds.
After 45 seconds move the toggle switch to the OFF
position. Lift the top cover of the water reservoir and add
the entire cleaner/water solution.
Leave the cleaner/water solution in the evaporator
for a minimum of 4 hours.
Step 6 Move the toggle switch from OFF to ICE. The
cleaner/water solution will flow through the water dump
valve and down the drain for 45 seconds.
Step 7 Move the toggle switch to the OFF position,
then follow the standard cleaning and sanitizing
procedures for the model ice machine you are cleaning.
Model
Water
Reservoir
Capacity
Mix Cleaner and Water
Use Ice machine cleaner
part number 000000084
only
Cleaner Water
QF0406A 48 oz (1.4 L) 32 oz (0.94 L) 16 oz (0.5 L)