Specifications

Installation Instructions Section 2
2-2
Part Number 000005546 12/09
Ice Machine Head Section Clearance
Requirements
Ice Machine Heat of Rejection
Ice machines, like other refrigeration equipment, reject
heat through the condenser. It is helpful to know the
amount of heat rejected by the ice machine when sizing
the air conditioning equipment where self-contained air-
cooled ice machines are installed.
Leveling the Ice Machine
1. Screw the leveling legs onto the bottom of the ice
machine.
2. Screw the foot of each leg in as far as possible.
3. Move the ice machine into its final position.
4. Level the ice machine - place a level on top of the
ice machine and turn each foot as necessary to level
the ice machine front to back and side to side.
NOTE: An optional caster assembly is available for use
in place of the legs. Installation instructions are supplied
with the casters.
Leveling Leg and Foot
QF0406A
Self-Contained
Air-Cooled
Self-Contained
Water-Cooled
Top/Sides 5” (12.7 mm) NA
Back 5” (12.7 mm) NA
!
Caution
The ice machine must be protected if it will be
subjected to temperatures below 32°F (0°C).
Failure caused by exposure to freezing
temperatures is not covered by the warranty. See
“Removal from Service/Winterization”.
Series
Condensing Unit
Heat of Rejection*
QF0406A 4000
*B.T.U. / Hour
!
Caution
The legs must be screwed in tightly to prevent them
from bending.
SV1606
THREAD LEVELING
LEG INTO BASE OF
ICE MACHINE
THREAD ‘FOOT’ IN AS
FAR AS POSSIBLE