Specifications

Maintenance Section 4

4-2 Part Number 000001759

B. Remove the ice thickness probe

• Compress the hinge pin on the top of the ice

thickness probe.

Ice Thickness Probe Removal

• Pivot the ice thickness probe to disengage one pin

then the other. The ice thickness probe can be

cleaned and sanitized at this point without complete

removal. If complete removal is desired, disconnect

the ice thickness control wiring from the control

board.

C. Remove the water distribution tube

• Disconnect the water hose from the distribution tube.

Water Distribution Tube Removal

• Loosen the two thumbscrews which secure the

distribution tube.

• Lift the right side of the distribution tube up off the

locating pin, then slide it back and to the right.

Disassemble for cleaning/sanitizing.

• Twist both of the inner tube ends until the tabs line up

with the keyways.

• Pull the inner tube ends outward.

Water Distribution Tube Disassembly

SV3135

COMPRESS

HINGE PIN TO

REMOVE

Caution

Do not force this removal. Be sure the locating pin is

clear of the hole before sliding the distribution tube

out.

SV1620

1. LIFT UP

2. SLIDE BACK

3. SLIDE TO RIGHT

DISTRIBUTION

TUBE

THUMBSCREW

LOCATING

SV1211

INNER TUBE

TAB

KEYWAY

INNER TUBE