Specifications

Installation Instructions Section 2

2-10 Part Number 000001759

GENERAL

Condensers must be mounted horizontally with the fan

motor on top.

Remote condenser installations consist of vertical and

horizontal line sets between the ice machine and the

condenser. When combined, they must fit within

approved specifications. The following guidelines,

drawings and calculation methods must be followed to

verify a proper remote condenser installation.

GUIDELINES FOR ROUTING LINE SETS

First, cut a 64 mm circular hole in the wall or roof for

tubing routing. The line set end with the 90° bend will

connect to the ice machine. The straight end will connect

to the remote condenser.

Follow these guidelines when routing the refrigerant

lines. This will help insure proper performance and

service accessibility.

1. Optional - Make the service loop in the line sets (See

below). This permits easy access to the ice machine

for cleaning and service. Do not use hard rigid

copper at this location.

2. Required - Do not form traps in the refrigeration lines

(except the service loop). Refrigerant oil must be

free to drain toward the ice machine or the

condenser. Route excess tubing in a supported

downward horizontal spiral (See below). Do not coil

tubing vertically.

3. Required - Keep outdoor refrigerant line runs as

short as possible.

Routing Line Sets

Caution

The 60 month compressor warranty (including the

36 month labor replacement warranty) will not apply

if the remote ice machine is not installed according

to specifications.

This warranty also will not apply if the refrigeration

system is modified with a condenser, heat reclaim

device, or other parts or assemblies not

manufactured by Manitowoc Ice, Inc., unless

specifically approved in writing by Manitowoc Ice,

Inc.

DOWNWARD

HORIZONTAL

SPIRAL

SV1204