Specifications

Section 2 Installation Instructions
Part No. 80-1175-3, 6/03 2-11
WATER SUPPLY AND DRAIN LINE SIZING/CONNECTIONS
Typical Water Supply Drain Installation
!
Caution
Plumbing must conform to state and local codes.
Location Water Temperature Water Pressure Ice Machine Fitting
Tubing Size Up to Ice
Machine Fitting
Ice Making
Water Inlet
33°F (0.6°C) Min.
90°F (32.2°C) Max.
20 psi (137.9 kPA) Min.
80 psi (551.5 kPA) Max.
3/8” Female Pipe
Thread
3/8” (9.5 mm) min. inside
diameter
Ice Making
Water Drain
--- --- 1/2” Female Pipe
Thread
1/2” (12.7 mm) min. inside
diameter
Bin Drain
--- --- 3/4” Female Pipe
Thread
3/4” (19.1 mm) min. inside
diameter
SV1755
ICE MAKING WATER
INLET TUBING
3/8” MIN. I.D. (0.95 cm)
WATER SHUT
OFF VALVE
SERVICE LOOP
ICE MAKING WATER
INLET FITTING
3/8” F.P.T. (0.95 cm)
18.00” VENT
(45.70 cm)
ICE MAKING WATER
DRAIN FITTING
1/2” F.P.T. (1.27 cm)
VENT
BIN DRAIN TUBING
3/4”MIN. I.D. (1.91 cm)
AIR GAP
OPEN, TRAPPED OR
VENTED DRAIN
DO NOT TRAP
MUST HAVE
AIR-GAP
INCORRECT