Specifications

Section 2 Installation Instructions
Part No. 80-1175-3, 6/03 2-1
Section 2
Installation Instructions
General
These instructions are provided to assist the qualified
installer. Check your local Yellow Pages for the name of
the nearest Manitowoc distributor, or call Manitowoc Ice,
Inc. for information regarding installation and start-up
services.
Ice Machine Installation Options
The ice machine head can be installed with the electrical
inlet, water supply inlet and refrigeration tubing entering
from the back or top of the ice machine.
The ice machine water drain must exit the back of the ice
machine.
Cut the top cover for top routing of electrical inlet, water
supply inlet or refrigeration lines.
1. Prior to cutting, mount top cover onto ice machine.
2. Use ice machine back panel recessed area as a
template to mark the underside of the top cover.
Do not cut up to or past this line!
3. Using a tin snips, cut top cover as needed:
A. Do not cut out entire area! Cut up to 1/8 inch to
marked line.
B. Cut out only what is needed. (If routing only
refrigeration lines out the top, cut just enough to
route these lines.)
Important
Failure to follow these installation guidelines may
affect warranty coverage.
TUBING CAN BE ROUTED
OUT BACK OR TOP
SV1752
TRIM TOP COVER
IN THIS AREA
SV1763